Universal switch panel for handlebar

Whats included:

Laser engraved and cut switch panel made of heavy duty industrial plastic laminate.

High quality waterproof rocker switches,

on/off, IP65, 2, 3 or 4 (should be used with power relay).

Stainless screws.

Aluminium mounting hardware, adjustable. For 20-30mm pipe

Crimp connectors.

3D printed housing in durable plastic.

CUSTOM TEXT!

⚠️ Please double-check at checkout that your text is correct.

You shoose your own text for each switch by typing it below in the custom text form, remember to hit save button.

Exampel: 1, LED BAR 2, HALO LIGHTS 3, REAR LIGHTS.

Optimal is 5 (max 6) character per row and max 2 rows per switch.

We will adjust text size if you use to long words!

INSTALLATION

· Mount base on handlebar pipe

· Mount housing and cables

· Crimp connectors with proper crimp plier

· Install panel and switches, only hand tighten the screws until seated.

· Leave bottom of box open so moisture can escape

· Fix cable with cable tie for strain relief

IMPORTANT

· Nuts are self-locking

· Screws and nuts are stainless steel

· Don’t use Loctite on nuts

· Only hand tighten the screws until seated

· Don’t clean panel with strong solvents

· Switches can handle 10A but we strongly advise you to use power relay

· Switches are IP65 rated on the front, if vehicle is used as a submarine it’s good to also seal backside of switches with Plastidip or other product for sealing electronics.

· Dont seal entire box, moisture must be able to escape.